Results of deep reflection seismic profiling in the Oberpfalz (Bavaria)

Summary. In order to investigate the target area of the Continental Deep Drilling (KTB) in the Oberpfalz a network of six seismic reflection lines was acquired in 1985 using the Vibroseis technique. The average length of these lines was 50 km. In addition, the 185 km long NW/SE striking line DEKORP 4 with its short appendix line 4-Q of 40 km length was acquired with the same technique. The results reveal a strongly structured upper crust. This is in contrast with previous surveys in the German Variscides which show a poorly reflective upper crust and a strongly reflective lower crust. Except for the S part of DEKORP 4 in the Oberpfalz area the Mono is only weakly reflective. In addition to the Vibroseis survey 96 shots along line DEKORP 4 were recorded by conventional reflection techniques and by portable reflection and refraction stations from university institutes and geological surveys in order to obtain wide-angle reflection and expanding spread data.     

Late Cretaceous-Paleogene Palynostratigraphy from the Arkhara-Boguchan Brown Coal Mine of Zeya-Bureya Depression, Russia

1IntroductionThe Arkhara-Boguchan brown coal mine is lo-cated in the western Arkhara depression,southeast-ern part of the Zea-Bureya Basin (Fig.1). Late Creta-ceous-Paleogene coal-bearing strata are well out-cropped at the Arkhara-Boguchan quarry. It contains four coal-bearing beds (in descending order): “Ve-likan”, “Promezhutochny”,“Dvoinoy”and “Nyzhny”, and composed of three sedimentary cycles (Fig.2). The lower cycle can be divided into two sub-cycles:the lowest sub-cycle is …     

Magnetic susceptibility variations of the Edicaran cap carbonates in the Yangtze platform and their implications for paleoclimate

1 INTRODUCTION One of the most intriguing phenomena in the late Neoproterozoic (~750 to 543 Ma) is the globa occurrence of thin carbonates that directly overlie glacial deposits in almost every continent (Kennedy 1996; Hoffman et al., 1998; Hoffman and Schrag 2002; Brasier and Shields, 2000; James et al., 2001 Jiang et al., 2003; Nogueira et al., 2003). These “cap carbonates”, commonly several to tens of meters thick, have attracted enormous interests because o their unusually negati…     

Crustal structure at the easternmost termination of the Variscan belt based on CELEBRATION 2000 and ALP 2002 data

The eastern margin of the Variscan belt in Europe comprises plate boundaries between continental blocks and terranes formed during different tectonic events. The crustal structure of that complicated area was studied using the data of the international refraction experiments CELEBRATION 2000 and ALP 2002. The seismic data were acquired along SW–NE oriented refraction and wide-angle reflection profiles CEL10 and ALP04 starting in the Eastern Alps, passing through the Moravo-Silesian zone of the Bohemian Massif and the Fore-Sudetic Monocline, and terminating in the TESZ in Poland. The data were interpreted by seismic tomographic inversion and by 2-D trial-and-error forward modelling of the P waves. Velocity models determine different types of the crust–mantle transition, reflecting variable crustal thickness and delimiting contacts of tectonic units in depth. In the Alpine area, few km thick LVZ with the Vp of 5.1 km s^− 1 dipping to the SW and outcropping at the surface represents the Molasse and Helvetic Flysch sediments overthrust by the Northern Calcareous Alps with higher velocities. In the Bohemian Massif, lower velocities in the range of 5.0–5.6 km s^− 1 down to a depth of 5 km might represent the SE termination of the Elbe Fault Zone. The Fore-Sudetic Monocline and the TESZ are covered by sediments with the velocities in the range of 3.6–5.5 km s^− 1 to the maximum depth of 15 km beneath the Mid-Polish Trough. The Moho in the Eastern Alps is dipping to the SW reaching the depth of 43–45 km. The lower crust at the eastern margin of the Bohemian Massif is characterized by elevated velocities and high Vp gradient, which seems to be a characteristic feature of the Moravo-Silesian. Slightly different properties in the Moravian and Silesian units might be attributed to varying distances of the profile from the Moldanubian Thrust front as well as a different type of contact of the Brunia with the Moldanubian and its northern root sector. The Moho beneath the Fore-Sudetic Monocline is the most pronounced and is interpreted as the first-order discontinuity at a depth of 30 km.     

青藏高原西部赛利普中新世火山岩源区:地球化学及Sr-Nd同位素制约

青藏高原拉萨地块西部赛利普地区新生代火山岩依据主量元素可划分为超钾质、钾质和钙碱性系列,主要的岩石类型为粗面安山岩、粗面岩,一个超钾质岩石的40Ar-39Ar年龄为17.58Ma,指示出火山活动为中新世.超钾质、钾质和钙碱性火山岩都显示出富集LREE及LILE(Th、U)、亏损HFSE(Nb、Ta、Ti)的特征.超钾质火山岩具有较高的K2O(6.31%～8.55%)、MgO(6.75%～8.96%)、Cr(270.7×10-6～460.4×10-6)、Ni(142.3×10-6～233.9×10-6)含量,较高的(87Sr/86Sr)i(0.71883～0.72732)和较低的εNd(-14.78～-15.37),指示可能起源于一个前期亏损并经后期俯冲作用改造的富钾的方辉橄榄岩富集地幔源区.钾质火山岩具有比超钾质火山岩低的K2O、MgO、Cr、Ni含量以及高的Ba、Sr含量,初始87Sr/86Sr为0.71553～0.71628,初始143Nd/144Nd为0.51197～0.51198,在空间上与超钾质火山岩共生,可能是前者母岩浆的演化产物.钙碱性火山岩具有较高的Sr(881.7×10-6～1309.2×10-6)、Sr/Y比值(50～108)和较低的Y(12.05×10-6～18.02×10-6),明显亏损重稀土Yb(0.93×10-6～1.30×10-6),类似于典型的埃达克质岩成分特征但相对高钾,并具有相对低的(87Sr/86Sr);(0.70928～0.71374)以及高的εNd(-7.90～-10.91),指示起源于富钾增厚下地壳物质的部分熔融.区域上拉萨地块超钾质岩、钾质岩与N-S向地堑系在空间上共存、时间上相吻合,由此本文认为拉萨地块中新世钾质.超钾质岩和南北向地堑系的形成可能与中新世早期北向俯冲的印度大陆岩石圈断离有关.     

青藏高原东南木里地区二叠纪苦橄岩的Os-Sr-Nd同位素地球化学研究

本文报道了在青藏高原东南木里地区发现的二叠纪苦橄岩和与其共生玄武岩的主微量元素地球化学特征以及Os-Sr-Nd同位素组成。苦橄岩和与其共生玄武岩受地壳混染作用影响较小。根据苦橄岩的Ti/Y比值和初始的Os同位素组成,将木里苦橄岩分为两类:高Ti/Y型苦橄岩和低Ti/Y型苦橄岩,其中高Ti/Y型苦橄岩具有高的γ_(Os)= 5.3～ 10.7和ε_(Nd)= 5.9～ 6.4,与全球典型洋岛玄武岩的Os和Nd同位素组成接近,代表了地幔柱源区的同位素特征;而低Ti/Y型苦橄岩具有低的γ_(Os)=-4.1～ 1.2和ε_(Nd)= 3.2～ 5.0,可能表明受到了SCLM(大陆岩石圈地幔)源区物质的混染。与其共生的玄武岩具有低的γ_(Os)=-3.5～-1.6和ε_(Nd)=-0.6～ 0.7,表明其来自于不同于低Ti/Y型苦橄岩也有异于高Ti/Y型苦橄岩的地幔源区,但是也可能受到了SCLM物质的混染。基于Nd-Os同位素的地幔柱与SCLM的二端元混合模型显示:低Ti/Y型苦橄岩可能是SCLM物质组分与地幔柱起源的苦橄质原始岩浆混合形成的;与苦橄岩共生的玄武岩可能是由地幔柱来源的玄武质岩浆与SCLM小比例熔融的熔体混合形成的。     

Wave Decay and Its Characteristics in Surf Zone

In accordance with the similarity between breaking waves and hydraulic jumps, the expressions for estimating wave decay and wave energy dissipation in the surf zone are derived based on the fundamental equations of fluid mechanics. Using the numerical solution of cnoidal wave theory, the various kinematic properties of waves in the surf zone, including the relative wave crest height, wave energy, and radiation stress are discussed. The values calculated with the method proposed in this paper are in good agreement with the experimental data gained by other researchers. The present expressions can be used in the studies of sediment transport on gently sloping beaches, especially on muddy beaches.     

A New Pursuit Mode of Nonlinear Wave Surface

The numerical mode of nonlinear wave transformation based on both the Laplace equation for water field and the Bemoulli equation for water surface is a kind of time-domain boundary problem with initial conditions. And the basis for establishing the numerical mode of nonlinear wave in time domain is to trace the position of wave free surface and to calculale the instantaneous surface height and surface potential function. This paper firstly utilizes the ‘0-1‘ combined BEM to separate the boundary by means of discretization of Green‘ s integral equation based on the Laplace equation, then separates the free surface of wave with FEM and derives the FEM equation of wave surface that satisfies the nonlinear boundary conditions. By jointly solving the above BEM and FEM equations, the wave potential and surface height could be obtained with iteration in time domain. Thus a new kind of nonlinear numerical mode is established for calculating wave transformation. The wave test in the numerical wave tank shows that the numerical simulation with this mode is of high accuracy.     

Action of Cnoidal Waves on Vertical Walls

Based on the 2nd order cnoidal wave theory, the characters of shallow water standing waves and their action on vertical walls are studied in this paper. The theoretical expressions of the wave surface elevation in front of and the wave pressure on the vertical wall are obtained. In order to verify the theoretical results, model tests were made in the State Key Laboratory of Coastal and Offshore Engineering at DUT. For the wave surface elevation in front of the wall and the wave forces on the wall at the moment when the wave surface at the wall surface goes down to the bottom of the wave trough, the calculated results coincide quite well with the experimental results. For the wave forces on the wall at the moment when the wave surface at the wall surface goes up to the top of the wave crest, the theoretical expressions are modified by the experimental results. For the convenience of practical use, calculations are made for the wave conditions which usually occur in enginering practice by use of the inves